Factory Direct Pricing • Quick Ship on all Products

Belt Widths (Frame is 1” overall wider than belt.) 6”, 9”, 12”, 15”, 18”, 21”, 24”, 27”, 30”

Loads Capacity: See Loading Table (Not to exceed 200 lbs static load per conveyor section supported by 2 stands. Maximum 350 lbs for multiple sections)

Stands: Stands are used at ends and to join conveyor sections. All dimensions for stand height are based on measurements from the floor to the top of the belt. Abbreviated, TOB. (For height ranges see Stands in Product Listing.)

Guard Rails: Removable 1” high guard rails are included on all models. Optional “flush” guard rails can be substituted when ordering. To avoid the 1” gap in the guard rails that occurs when joining individual sections, please request continuous guard rails. Continuous guard rail must be installed after sections are assembled. (For guiding product sideways on the belt, see Accessories, Adjustable Guide Rails.)

Minimum Part Transfer: End-to-end transfer with back pressure = 0.5” long. End-to-end without back pressure = 3” long.

Maximum incline: 10° up or down hill. “Tilt” option stands are required when joining two non-parallel sections. (Note: SmartMove® Conveyors are designed with a low friction surface that enables it to easily slide under packages. This is the opposite of conveyors with high friction belting. Please consider purchasing from another conveyor manufacturer if you are depending on the belt friction to carry items with a slope of over 10°.)

Operating Temperature: 0°—185° F. (Please consult factory for exceptions and specialty belting with higher intermittent temperature ratings.)